Gmc 2011 Savana Manual de usuario descargar pdf (Pagina 331)

Black plate (65,1)

GMC Savana Owner Manual - 2011

Vehicle Care 10-65

After the tires have been

rotated, adjust the front and rear

inflation pressures as shown on

the Tire and Loading Information

label. See Tire Pressure on

page 10‑58 and Vehicle Load

Limits on page 9‑12.

Reset the Tire Pressure Monitor

System. See Tire Pressure

Monitor Operation on

page 10‑60.

Make certain that all wheel nuts

are properly tightened. See

“Wheel Nut Torque” under

Capacities and Specifications on

page 12‑2.

{

WARNING

Rust or dirt on a wheel, or on the

parts to which it is fastened, can

make wheel nuts become loose

after time. The wheel could come

off and cause an accident. When

changing a wheel, remove any

rust or dirt from places where the

wheel attaches to the vehicle. In

an emergency, use a cloth or a

paper towel to do this; but be sure

to use a scraper or wire brush

later, if needed, to get all the rust

or dirt off. See If a Tire Goes Flat

on page 10‑73.

Lightly coat the center of the

wheel hub with wheel bearing

grease after a wheel change or

tire rotation to prevent corrosion

or rust build-up. Do not get

grease on the flat wheel

mounting surface or on the

wheel nuts or bolts.

Dual Tire Rotation

When the vehicle is new,

or whenever a wheel, wheel

bolt or wheel nut is replaced,

check the wheel nut torque

after 100, 1,000 and 6,000 miles

(160, 1 600 and 10 000 km) of

driving. For proper wheel nut

tightening information, see

“Removing the Flat Tire and

Installing the Spare Tire” later in

this section, under If a Tire Goes

Flat on page 10‑73. Also see

“Wheel Nut Torque” under

Capacities and Specifications on

page 12‑2.

1 2 ... 326 327 328 329 330 331 332 333 334 335 336 ... 409 410

Comentarios a estos manuales

Sin comentarios